DuraVent 46DVA-CL33KFB 3″x3″ Co-Linear Direct Vent Factory-Built Reline Kit

DuraVent 46DVA-CL33KFB 3×3 Co-Linear Direct Vent Factory-Built Reline Kit

DuraVent is the first manufacturer to have a UL-listed relining system for factory-built chimneys. Our co-linear direct vent relining system can be used when installing a direct vent insert into an existing factory-built chimney. When an insert is installed into an existing factory-built chimney or b vent, relining the existing chimney is critical for proper performance and safety.

Note: Plate must be larger than the current pipe or conduit (Bottom Plate Dimension 14″). Fold brackets into existing diameter to secure the high-wind termination cap in place. Flex does not need insulation!!!

Factory-Built Reline Kit includes:

High-Wind Termination Cap
Two pieces of Aluminum Flex Lengths (exhaust marked red)  (2) 3”x 35’ Lengths
4 hose clamps

Bottom Plate Dimension 14″

Also available:

46DVA-CL34 4 x 6 Termination Kit (includes 3′ and 4″ flex)

46DVA-CL34KFB 3×4 Co-Linear Reline Kit AL Flex inc: High Wind term Cap, 2 FLex Alum flex length and 4 hose clamps

46DVA-CL33  Co Linear ‘Masonry Chimney Conversion Kit (includes: 2 flex runs 35 ft, and high wind cap)

46DVA-CL33-25  Co Linear ‘Masonry Chimney Conversion Kit (includes: 2 flex runs 25 ft, and high wind cap)

46DVA-CL33H  Co Linear Termination Kit AL (includes: Termination Connector, Flashing, High Wind Cap, 1-30 ft 3″ Al Flex, 1-4 ft 3″ Al Flex,)